top bar

Toptica iBeamSmartCW

Summary:Controls the iBeamSmart laser series from Toptica.
Author:Joran Deschamps, EMBL, 2018
Platforms:All platforms (uses serial interface)
Example Config File:None
Micro-Manager version:>=1.4.22

The Toptica iBeamSmart lasers are usually controlled using two channels (see Toptica's software Topas). The FINE settings affecting only the first channel, while the digital modulation (optional) acts only on the second channel.

This device adapter (module iBeamSmartCW) makes use of a hidden control mode (called CW) that simplifies the interface. In the CW mode, the laser is controlled using a single channel while allowing FINE and digital modulation (if the option is present).

Upon quitting Micro-manager, the device adapter switches back the laser to normal control mode.

If the laser is in CW mode, it will no longer be controllable by the Topas software from Toptica. This can happen when Micro-Manager crashes unexpectedly and the device adapter is not properly unloaded. Before using Topas, load the device adapter in Micro-manager and quit the software. The laser will then be usable with Toptica's software.

In order to switch faster to normal mode, another device is available in the device adapter: iBeamSmartNormal. This device does not allow controlling the laser as it sole purpose is to switch back the laser to normal control mode.

This device adapter has been tested with Micro-manager 1.4.22 and 2.0.0-beta on Windows 7.

© Micro-Manager : Vale Lab, UCSF 2006-2011 | All Rights Reserved | Contact